Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »

After confirmation of a valid License key for this installation, you will be presented with an introduction to the Configuration Wizard, looking much like the following text:

 

Configuration Wizard Introduction

 

You are given three options at this point:

  • YES - Immediately launches the Configuration Wizard.
  • NO - Will not launch the wizard, and instead open you in to the Admin Console itself at the default view.  From there you may manually configure your Swift MEAP™ Admin Console.  If you close and re-open your Admin Console URL prior to configuration completion, you will again be prompted to use the wizard.
  • NO - Do Not Prompt to Run Wizard Again - This will open you inside the Admin Console so that you may manually configure the Swift MEAP™ Admin Console, and prevent the wizard from re-launching on next open before you have configured the Console.

 

The Server Configuration Wizard may be run manually at any time by clicking the link in 'Administrator -> Global Settings'. Click on the Run server configuration wizard link.  This may even be run after setting up a fully configured Swift MEAP™ server.

 

  • No labels